I just switched from a wire wheel rear axle to steel wheels. The E brake
link rods from the swivel assembly to the arm going into the brake drum are
too
short. This is for a half elliptical spring axle
Will beg, borrow, trade, steel or buy for a set.
No reasonable offer will be refused.
Or is there a where to source these from a speed shop? If so, the distance
from the center of each clevis pin would be appreciated. My guess is a 1/2"
longer at each side.
If I could weld, I suppose that I could drill the rods out of the pin links
and put in longer rods. But I can't weld.
David Oliner
|