Phil,
I had the same floor pan problem on my BE. I made a filler out of
aluminum that fit in the curved depression. I used longer bolts to
mount the pedals and made "beveled" spacers for the nuts on the bottom
side. I love the floor mounted pedal. If you need measurement to drill
holes in the floor I'd be happy to send them to you.
Are you running a 948 with a 1 1/2" carbs. Am I incorrect in thinking
these are too big?? Seems like a lot, but I'm usually wrong about these
things.
Dave
59 :{)
59 MGA 1500
05 MCS
Phil Nase wrote:
> I drove the BE today and I don't think I'm getting WOT. Anyone have a good
> alternative to using the cursed little clamping screw. I think mine is
> unoriginal but damn. I'm in there with ignition wrenches. Nothing else
> will fit to grab that sucker.
>
> I running 1 1/2 SUs.
>
> I had a bad flat spot at 60 - 70 mph and it wouldn't pull past that. I went
> one flat richer and that helped but I still think I'm not getting full
> throttle.
>
> While I'm on the throttle issue. I have replacement floor pans with the
> depression under the thottle pedal. I dropped a pedal down from above
> rather than floor mounting it but I'm not happy with it. What are others
> using on the floor.
>
> Phil Nase
|