Re: pressing piston pins

["bjshov8" <bjshov8@comcast.net>]

I've seen this done at machine shops, but I think they heat the rods to
higher temperature.  I don't think it would hurt to try it though.  At my
dad's shop we had a hydraulic press that did this, without heat.


>   Anyone here installed piston pins? Can I just put the pins in the
>   freezer and the rods in a 250 degree oven and then carefully push
>   them in?

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to majordomo@autox.team.net  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!