Well I put the left side shock and A arm on with no problem. I looked
closer at the right side A arm and the inner front fulcrum is bent a few
degrees back making it impossible to line up the trunnion with the shock
lever arm. It's bent about the width of the lip on the bushing.
Can the A arm be tweaked or should I replace it? I got the set about 18
months ago. I don't know if I can have it replaced.
Phil Nase
http://home.comcast.net/~philnasecpa
| Phil Nase wrote:
|
| > Last evening I started hanging the right front A arm with disc brakes.
I
| > already had the shock mounted.
| >
| > With the bushings in the lower fulcrums I slid the bolts in. On the
front
| > side the bolt does not exit the hole at the center. I can move it a bit
but
| > not entirely centered.
| >
| > Also when raising up the hub the trunnion doesn't line up behind the
shock
| > lever.
|
| Phil
|
| Lower A arm bushings....
| Stick one bushing (rear facing) on each side, put the A arm up into the
| frame, insert the pins. Now install the 2nd bushing in the bigger hole,
| put on the washer and nut. A slight tap with a hammer is all that should
| be needed on new bushing just to line up the pin with the holes.
|