Thanks Tim, I'll keep that in mind. The pedal doesn't feel spongy, but I guess
there could still be internal leakage in the slave? I would like to know if the
roller T.O. bearing dimensions are the same as the stocker though.
John
Wallace, Timothy A. wrote:
>I had a similar problem with a '78 Midget where the clutch would not
>completely grab. After pulling the engine and transmission (suspecting the
>clutch was bad ) I found that the PO had tried to fix 'your' problem by
>fiddling around with the slave cylinder rod length and then installing some
>pipe bushes to make it longer when it was cut too short. I rebuild an old
>slave cylinder off my parts car and never had a problem again. Since the
>'74 has a hydraulic clutch, I would check the hydraulics first to see if the
>problem is with that. They may have installed the slave incorrectly or
>tried to mess with it and screwed things up.
>
>Tim
>Fuquay Varina, NC
>'73 Midget
|