Hello,
I got a straight 4 to 1 exhaust header in 2" (I beleive) and was planning to
bring the exhaust to the back of the car with a straight pipe (diameter matched
with the exhaust), followed by a 900 turn and a muffler (like a small normal
(ie: not ricer) honda civic 2 door muffler) behind the gaz tank followed by
another 900 turn to get out...
Can anyone outline the stupid mistakes that I am doing in this setup (please no
comments about the 4 to 1 which is not as good as the 4-2-1, I have the part
and are not willing to go buy another one :-)...
Regards, cyrille
|