Grunts, groans? Pipe was too short.
I was torquing the main bearing bolts on a motor a few weeks ago, and since
it was still just a nekkid block, it was a pain to grip it tight enough to
easily reach proper torque. I noticed a chunk of left-over 1.5"dowel about
3 feet long in the scrap pile and that it fit nicely into the cam bore.
Between the long handles of the torque wrench and the dowel, it was no
strain at all. As I get older, I'd rather think hard than work hard.
Glen
> Hi All, long story here and it would reveal my stupidity to go into it.
> I bent two (ribcase) forks in the same day early on in my Sprite's life.
> First one was the original and the next was a spare I had. Anyway, with
> two bent forks and no more spares handy I resorted to the old BIG VISE
> and HEFTY PIPE trick. Grunts, groans, and bracing my feet against a
> concrete wall pulled both of them back to straight. It wasn't easy but
> it did work flawlessly until I converted to a 5-speed in 1991. Anyone
> with no spare forks and a handy gorilla could likely do the same.
> Jack
|