chuck, I have had good experience with Ted Schumacher.
(tsimportedautomotive.com). The cam that came out of my old engine
was covered in rust, much like yours, I sent it to Ted and he cleaned
it up perfectly.
Larry
On Jul 18, 2005, at 6:06 PM, cfchrist@earthlink.net wrote:
> i have a damaged (it was left sit on a wet surface and the bearing
> journals are damaged!) very interesting custom ground cam shaft (he-
> he-he!) wich i'd like copied onto a good core i have here. does
> anyone have any place they'd reccomend or have had experience with?
>
> thank you!
> chuck
> (pssst! it's out of a past SCCA "run off's" winning F production
> midget! *grin*)
>
>
> cfchrist@earthlink.net
> EarthLink Revolves Around You.
--
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question and you're a fool for the rest of your life.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.
|