Mike,
What I mean is that when you insert the bearing into the hub it doesn't
go quite all the way. It might seat into the hub, but the edge of the
bearing will be higher than the side of the hub that the axle bolts to.
I'm talking about a very slight amount that the edge protrudes above the
surface of the hub. This keeps the axle flange from seating completely
on the surface of the hub and causes a leak.
This seems to be a fairly common problem as I have experienced it myself
and know several others that have, as well.
David.
On Mon, 21 Mar 2005 09:25:12 -0500 "MICHAEL CARPENTER"
<MAIL4CARPENTERS@peoplepc.com> writes:
> Hi David,
>
> Yep, my Seven uses a Nash Metropolitan rear axle which uses the same
> hubs as
> a Spridget. I think that I understand about the wobble that you
> mention but
> I am not sure that I understand about the bearing standing proud of
> the hub.
>
> Thanks for your help,
>
> Mike C
Your messages not reaching the list?
Check out http://www.team.net/posting.html
*** unsubscribe/change address requests to majordomo@autox.team.net or try
*** http://www.team.net/cgi-bin/majorcool
*** http://www.team.net/mailman/listinfo
*** Archives at http://www.team.net/archive
*** Edit your replies!
|