I guess I'm missing the hole in the rear boot floor. Should it be center
below where the license plate light wire is?
I took your previous advice and already ran the white wire to the fuel pump.
Do you recommend running that over the top of the tank also. The pump is
located on the right rear bulkhead between the tunnel and spring.
I made the mistake of putting the new sender in the first time with the cork
gasket dry. I had some gas on top of the tank. Will Hylomar solve that
problem?
Phil Nase
http://home.ptd.net/~nase
----- Original Message -----
From "Frank Clarici" <spritenut at exit109.com>
To: "Phil Nase" <nase@ptd.net>
Cc: <Spridgets@autox.team.net>
Sent: Sunday, January 09, 2005 7:51 PM
Subject: Re: Bugeye rear harness routing
> Phil Nase wrote:
>
>
>> Where should the wire pass thru the boot floor?
>
> The tank wire goes down in the back of the tank, rear most hole in the
> boot floor. It runs down the center of the gas tank.
> Now is also a good time to run a seperate ground wire from one of the
> sending unit screws to a good ground. Although the tank is bolted to the
> body for a ground, it's also mounted on those rubber strips which can (and
> do) impeed the ground resulting is lots of head scratching when the fuel
> gauge doesn't work.
> If an electric fuel pump is in your future, run that wire now too.
> A white one to keep with the color codes.
>
> --
> Frank Clarici
> Toms River, NJ
|