Thanks Gerard, that is another data point. It is an interesting way to
measure it, but does tell you what the factory thought was necessary
clearance with the stock spring rates. I suppose the dimension under the
outer rockers might be 7" in this case? I am not familiar with Leading
Dimensions. Is it a book, or technical drawing perhaps?
John
Gerard wrote:
> John,
>
> Leading Dimensions specs Minimum Ride Height at 5 inches between the
> ground and the bottom of the factory exhaust pipe. This measurement is
> shown on the drawing at just slightly forward of the A-post.
>
> Gerard
>
> At 8:46 AM -0500 12/17/04, John Caffrey wrote:
>
>> Did the factory ever publish a figure for ride height? I had asked
>> this question over on the Spritespot and it went unanswered, which
>> makes me think the factory never specified ride height. Just curious,
>> but would like to predict what the R.H. will be with 1" or 2"
>> lowering springs. The racers use the outer rocker panel for a datum,
>> and my Sprite used 4.25" front and 4.5" rear. How much was that car
>> lowered from stock?
>> John
|