I bought it off a guy at SpriteSpree 03. Had a sticker on it, don't
recall what it said. But this could be it.
So where do I get a new one?? Or do I let chuck weld this one and cross
the old finners? And if this IS the problem, then welding is a temp
fix.
Larry
On Aug 27, 2004, at 4:38 PM, DLancer7676@cs.com wrote:
> In a message dated 8/27/04 1:35:17 PM Pacific Daylight Time,
> macy@bbl.med.upenn.edu writes:
>
>
> what in the H
> could cause this part to fail not once, but twice??
>
>
> Let's see. . .I know you, so I know it isn't your diet. 8^) You
> didn't happen to put an oriental a-arm in the car did you? From Vicky
> Brit or Moss?
>
> --David C.
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
> MailScanner thanks transtec Computers for their support.
--
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Administrator/Manager
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
The bottom line: Sure, there's pain in adopting the Mac. But if I accept
that, I get to use a computer that works, and that pretty much does
what I
expect and want a computer to do.
Stewart Alsop
FORTUNE.com
Monday, June 25, 2001
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|