No no its not what your thinking.
I have the entire rear dissassembled on the BE project. Hubs and diff out.
I had the entire unit when it was fully assembled sand blasted and now I
want to be sure the media is not in the diff.
Can I clean the diff sufficiently without pulling it apart. Hopefully I can
just pull the universal joint flange cover off and clean the rest. I am
leary of reassembling the entire thing because of preload settings etc.
Can I powerwash the diff or should I use a solvent in the parts washer. I'm
guessing water in the diff would be a bad thing.
How about powerwashing the rear axle case.
thanks as always.
Phil Nase
|