Blocked return hole in the MC?
-g
At 5:59 PM -0500 3/14/04, John D'Agostino wrote:
>Thanks for all the suggestions, this is what I've found, so far.
>I thought I had air in the line, so I used a pressure bleeder to try and get
>it all out. I ran about a quart through it and didn't see air bubbles.
>Perhaps some air is still in the line? I pulled the slave cyl push rod all the
>way out until the release bearing was touching the pressure plate then had my
>daughter pump the pedal a few times. First I removed the boot so I could see
>what was going on, the piston moves out an inch or so, then goes back in when
>the pedal is released, like it's being sucked back. Seems to me it should move
>out and stay until the slack is taken up.
>
>Thanks again,
>J
|