And for the packing piece which goes betwen the clamps and the chassis rail
cut a piece out of a vinyl floor tile - about 2mm.
Then you need to work out which side to put it! There has been a LOT of
discussion and confusion on this - check the archives!
Guy
----- Original Message -----
From "Frank Clarici" <spritenut at exit109.com>
To: "Jim Baustian" <jabaustian@att.net>
Cc: <spridgets@autox.team.net>
Sent: Sunday, February 29, 2004 11:36 PM
Subject: Re: Steering Rack Assembly
> Jim Baustian wrote:
>
> > What type of material is used for this packing?
>
> Originally it was paper. I have been using electric tape with no
> problems. No packing and the rack will be loose in the mounts, too much
> and it will not clamp down correctly.
> Wrap it once around with tape and try it, sometimes 2 wraps works.
>
> --
> Frank Clarici
> Toms River, NJ
> Back up to too many sprites again.
> http://www.exit109.com/~spritenut/
|