Gasket Works
http://www.headgasket.com/gaskets.html
----- Original Message -----
From "Glen Byrns" <grbyrns at ucdavis.edu>
To: <spridgets@autox.team.net>
Sent: Wednesday, October 29, 2003 3:39 PM
Subject: Re: Head Gasket
> A larger drill bit worked well for me. Where did you get the thicker
copper
> gasket?
>
> Glen
>
> > In an attempt to lower the CR on an engine I'm getting ready to replace
> the
> > stock head gasket with a thicker one. I'm also going to replace the head
> > studs with ARP studs at the same time. I know the stud holes need to be
> > chamfered (they needed it last time but I did not do it). Any
> > recommendations on the best was to do this? Should I just use a drill
bit
> > somewhat larger than the hole or do I need some kind of counter sink?
|