wow great info, thanks a lot. As you can no doubt guess, I'm about to put the
trans and motor together. I'm curious, since it's such a vital step and not
easy to get back to, does anyone have tips at this stage (again, a 1500 and
four speed)of the thing to be SURE TO DO or, on the other hand, to BE SURE NOT
TO DO as I bolt these guys up? The throwout bearing and entire clutch are new,
any treatment to the disc? scuffing? the flywheel was lightened surfaced and
balanced. I plan to use an alignment tool.
Thanks again,
Mark M
|