Eugene,
Bar-b-que the sucker! No joke, it worked wonders on the tank I put in my
wife's Traveller. I stoked up the barby with a large load of Kingsford and
plugged up the outlet hole on the side of the tank. Set it on the grill and
filled it to the top with water through the fill pipe. After about an hour
it was near boiling and I left it there until it cooled. Swirl and dump and
then take a look inside and see how much difference it made. The only
drawback is the neighbors who look over the fence figure you're totally
nuts. In my case that wasn't much of a revalation.
Glen
> My 66 Sprite has been sitting for about 14 years. The
> gas has evaporated, so there is a layer of gunk on the
> bottom of the tank, there is a small amount of rust
> visible through the inlet as well but can't see very
> far into the tank.
>
> What have other listers used to clean/treat gas tanks
> in similar condition?
>
> Thanks,
>
> eugene
> ---
> 66 Sprite
> Fort Worth, TX
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|