Hi Larry,
Question here. Aluminum heads on cast iron blocks were a problem to seal,
until some of the across the big sea folks came up with good gasketing. So,
is this head a problem keeping it in gaskets and what special gasket and
care are required to make a successful marriage between the 2?
Later, Paul A
----- Original Message -----
From "Larry & Sandi Miller" <millerls at ado13.com>
To: "Spridget" <spridgets@autox.team.net>
Sent: Sunday, August 24, 2003 7:52 PM
Subject: Re: engine health
> Having had both, my ass in the seat tells me that $ for $ the aluminum
head
> out performs the steel version.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|