"Aldon Distributors"
Aldon did a PerTronix equipped 45D mechanical curve for my 8.3-1 motor,
based upon a planned (Judson) 6psi boost
curve. Less than $300 including shipping.
Bill Perry got the dizzy. In checking it on a
distributor machine, it did not match the
written curve provided. Bill shipped the
dizzy up to me in CT so Pete Sachs guys
could check it out on their machine(s). Sure enough....wrong curve.
Shipped it back to Aldon after trading
e-mails. Returned in a heartbeat with the
"correct" curve...Aldon paid all shipping
costs (by Air..both ways).
Morals:
1.Check this part as you would any other
before installation.
2.Despite the initial error, Aldon corrected
the situation ASAP and covered any and
all additional costs in doing so (inc. shipping by Air both ways to
correct error) along with appropriate apology.
Aldon has "stored" curves for about every
configuration of Series A engine probably
ever built. Give them the spec of the motor and the octane of fuel you
are running and they will provide what the
motor requires, with or w/o vac. capability.
Always insist upon a written "map" of
the curve and DO check it before installation.
Cap'n. Bob
'60 :{)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|