You could also remove the fitting and have a competent machinist
turn it on a lathe and take a few thou off.
On Monday 11 August 2003 02:45 pm, John Gottstein wrote:
> Hi,
>
> Well, the new 1500 engine is coming out pretty well but I've run into
> another hopefully small problem that I need some opinions on. I
> accidentally put some gouges in the soft metal (aluminum?) on the face of
> the part that the oil filter spins onto (where the rubber seal sits). Is
> there any way to easily grind down the circular flat area so that I don't
> get oil spurting from the side of my oil filter? The gouges aren't too
> deep, but can't just be filed down, I presume.
>
> Thanks,
>
> John
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|