Daniel,
Clarke's Spares in Pennsylvania offers the proper size bronze bushings for
the
Sprite/Midget. Todd Clarke can be contacted at clarkespares@worldnet.att.net.
The
bushes are slightly too short lengthwise, but it does not seem to be a problem
with
the ones I installed. If I had it to do all over again, I would order three,
cut
one in half, lengthwise and press the shorter half into the bore a ways and trim
off both ends, but it is not necessary.
Mike MacLean-60 Sprite
Daniel1312@aol.com wrote:
> Hi list
>
> Does anyone have any of the little brass(?) bushes that go into the clutch
> and brake pedals? Or has anyone every had a batch made? I'm after a couple
>so
> I can be sure that the pedals are properly overhauled. Also, I guess the
> bushes were reamed after fitting or just opened out with emery paper or just a
> push fit.
>
> Thanks
>
> Daniel1312
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|