I found a couple of small setscrews on mine that seem to hold an aluminym plate
(under the brass pints plate) in place. I took 'em out last night, but the
thing still wouldn't budge. I'm going to try some penetrant and see if that
helps.
-=Chris
Chris King - cbking@alum.rpi.edu
http://mywebpages.comcast.net/kvcbk/
---------- Original Message ----------------------------------
From "Steve Garrett" <stevegar at dol.net>
Date: Wed, 4 Jun 2003 14:14:41 -0400
>Chris, As I recall on mine there is a screw on the outside of the case that
>you loosen to loosen the plate inside. It then lifts out. steve
>
>-----Original Message-----
>From: owner-spridgets@autox.team.net [mailto:owner-spridgets@autox.team.net]
>On Behalf Of Chris King
>Sent: Wednesday, June 04, 2003 10:43 AM
>To: spridgets@autox.team.net
>Subject: Mallory dizzy question
>
>I have an older Mallory dual point dizzy I'm cleaning up and inspecting.
>Does anyone know how to remove the points mounting plate so I can take a
>look at the advance mechanism underneath? There seems to be no obvious way
>it comes apart. (So I'm probably missing the obvious, as usual!)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|