Re[2]: Rollbar fabrication

Hello Guy,

       i did NOT mean to make the roll bar from electrical conduit,
       but rather to use either their greenlee 555 bender or their
       hydraulic ram benders to make the bends in the APROPRIATE
       tubing. they should have the EQUIPMENT, not the materials
       needed.




-- 
Best regards,
 Bill                            mailto:pythias@pacifier.com
   "66 Sprite

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets