Check out this link:
http://www.chicagolandmgclub.com/driveline/1001/jasw.html
Also, make sure the bushings are all the way into the bores.
The inner end of the bushing needs to be flush at the wall
of the carb throat. If you fit it flush to the outside and
there's a gap at the carb throat, you'll have an air leak
past the throttle disc.
Chris K.
> Thanks to all who helped. On Jon P. SoCa's advice I found
> the problem. The throttle shaft in one carb was sloppy big
> time. I got a rebuild kit form Mo$$ that has bushings for
> the shaft. Question What do I use to ream out the old
> shaft holes? I mic-ed the bushing out (light compression
> 317") and it looks like 5/16" (.3125") just might do it,
> but I sure don't want screw it up more than I have to.
> Thank Rog
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|