RE: Oil pressure gauge help

As I remember this from a previous thread, some teflon pipe tape and a
judicious hand can result in a leakless "adaptation" of this fitting.  I too
have not yet done it but plane to in a few days.
-JohnD

        -----Original Message-----
        From:   Larry B. Macy, Ph.D. [SMTP:macy@bbl.med.upenn.edu]
        Sent:   Thursday, April 03, 2003 8:44 PM
        To:     spridgets@autox.team.net
        Subject:        Re: Oil pressure gauge help

        Chris, Jack is right and my post is wrong (I said 1/4"). The tapered

        thread is supposed to seal. Almost bet you have a leak ;-)

        Larry

        ///  Send your messages to spridgets@autox.team.net
        ///  unsubscribe/change address requests to majordomo@autox.team.net
or try
        ///  http://www.team.net/cgi-bin/majorcool
        ///  http://www.team.net/mailman/listinfo
        ///  Archives at http://www.team.net/archive/

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets