In a message dated 2/6/03 6:57:35 PM Eastern Standard Time,
wolfbj@prodigy.net writes:
> Grind the area out, and weld it up. I am thinking this way, because in
> the Midget Restoration book, Lindsay says "a better solution to spot welds
> is to seam weld the two flanges.
This would seal the flanges against moisture penetration, as well as
eliminate the rust that is already there.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|