Chuck,
I guess you must be right. I had assumed from earlier posts that it
was only a fraction of an inch mis-aligned. But then I have never
even seen a LHD spridget so didn't realise the extent of the problem!
>From the fabricated headers I have seen, the easiest place to cut and
re-weld would seem to be where the pipes are welded to the thicker
plate that matches up to the head... but then, what do I know!
Guy
----- Original Message -----
From "Charles Christ" <cfchrist at earthlink.net>
To: "Guy Weller" <guy@weller-lakes.freeserve.co.uk>;
<spridgets@autox.team.net>
Sent: 05 February 2003 21:33
Subject: Re: LCB header won't clear steering!
> ya see the problem is a right hand designed header puts the center
tube
> tight about dead center of the path of the steering shaft. all
this talk
> about bending it a bit is not going to make it fit
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|