As I sit here and read about the blocks warping, I wonder. If the head torque
sequence was
reversed for removal, and loosen each bolt/nut a little each time, rather than
all at
once.........
Brad
Andrew Weaks wrote:
> This is interesting, I am eventually going to rebuild my CRX motor and when I
>heard this
> about bending blocks it kinda intimidated me. Didn't sound quite right though
>to me but I
> forgot some motors are aluminum. I knew the list would be able to figure it
>out. Not sure
> the older cars have this problem, I think my block is iron. I guess I will
>find out.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|