Frank,
What were the markings on the bearings? If it is an ISO standard bearing
it should have the same envelope if the series (e.g. 203, 207) is the
same.
Mike Myers
HAN7
On Sun, 17 Nov 2002 22:34:24 -0500 Frank Clarici <spritenut@Exit109.com>
writes:
It seems the bearing was a couple mms too thick.
> It
> looked the same by eye, it was made in England. The replacement I
> had
> was a used German bearing. It worked.
>
> So did this car have a wrong replacement axle bearing? The bearing
> on
> the other side is the same.
> Go figure!
> --
________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Visit www.juno.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|