In a message dated 10/27/02 3:58:32 PM Eastern Standard Time,
PilotRob@webtv.net writes:
> Otherwise, it's "off with your head" and a
> re-check for "flatness" of surfaces before
> trying again, IMHO.
>
Reiterating a bit, but How about a compression check before disturbing the
suspected head gasket seal? If you don't get the compression values before
pulling the head, you may never really know what is causing the problem.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|