spridgets
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [midgetsprite] Snap On Tool

from [Unknown] [Permanent Link][Original]
To: midgetsprite@yahoogroups.com, spridgets@autox.team.net
Subject: Re: [midgetsprite] Snap On Tool
Date: Sun, 20 Oct 2002 20:38:49 EDT 
In a message dated 10/20/02 11:21:32 AM Eastern Daylight Time, 
toyman@digitex.net writes: 
> measuring bolt-nut torque in inch pounds.

If you work on small engines, like tillers and lawn mowers, 
 the torque is frequently measured in inch pounds.

--David C.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • Re: [midgetsprite] Snap On Tool, Unknown <=
Previous by Date:  update - mistaken identity, Unknown
Next by Date:  Re: Arrrghhh!!!!! ;-(, Unknown
Previous by Thread:  update - mistaken identity, Unknown
Next by Thread:  Adventures in engine pulling/ring gear installation, Unknown
Indexes:  [Date] [Thread] [Top] [All Lists]