According to Horler - aluminum rocker shaft pedestals were used on 948's
until Feb. '62, when they were changed to cast iron pedestals.
Rick
'59 Sprite
----- Original Message -----
From "Jon Paschke" <JPASCHKE at bak.rr.com>
To: <spridgets@autox.team.net>
Sent: Thursday, September 05, 2002 1:02 PM
Subject: rocker shafts - pedestals - 1275
> Hi All,
> A question, I was going through my boxes-O-parts looking for a usable
rocker
> shaft and found an old A series rocker setup with aluminum pedestals
instead
> of the steel ones. Does anyone know what motor used these? They are about
13
> oz lighter that the steel ones.
> TIA
> Jon
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|