"Wm. Severin Thompson" wrote:
>
> Hey y'all,
>
> Any suggestions for long term storage of machined parts?
Watch some of those spray lithium greases, they use a water base
propellent. Water and oil don't mix (except when your head gasket blows)
and the grease floats on top of the water.
Get yourself some Cosmoline spray from Eastwood. It comes in a spray
can, is made of a wax based material and keeps parts for decades.
Also do not plastic bag and plastic box, you are creating a double vapor
barrior. Any moisture around when you put the stuff in an air tight bag
will stay there and keep condensing on your cold steel parts.
Store them in a brown bag or cardboard box then in a plastic tote. The
paper will absorb any moisture.
I did what you are doing to a cam some years back, you wouldn't believe
the pits on the lobes when I opened it up 5 or 6 years later.
and it was just lithiumed and stuck in a plastic bag.
--
Frank Clarici
Toms River, NJ
http://www.exit109.com/~spritenut
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|