It looks like I can remove the rear bearing cap with the backplate in place;
it's in plain sight. The front one looks like it's under some sort of cross
plate. I'll have to double check my manual to see where it is.
I saw somewhere on the web (maybe Chris Kotting's site) a procedure for
changing 1500 bearings with the engine in the car, so I figure I can use this
method and not have to completely remove the crankshaft.
-=Chris
Chris King - cbking@alum.rpi.edu
http://mywebpages.comcast.net/kvcbk/
---------- Original Message ----------------------------------
From PilotRob at webtv.net (Robert E. Shlafer)
Date: Sat, 29 Jun 2002 00:39:51 -0400 (EDT)
>Chris-
>
>Can you change the rear main bearing
>without removing the engine back plate?
>
>
>
>
>Cap'n. Bob
> '60 :{)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|