I figured it would be a thick spacer, and the fabrication time might not justify
the results. I don't always have the most sensible ideas. More a theory
question
than anything else, I suppose. It's not like I have this big cache of FWD
wheels
lying around.
Jim
Gerard wrote:
> I'm no expert in this area, but one set I looked at had nealy 5" of
> backset. You'd need a spacer that was about 1.25 inches. Of course it
> depends on wheel width. Way too much and too much trouble too, if you ask
> me.
>
> Gerard
>
> At 11:07 AM -0400 6/27/02, Jim Juhas wrote:
> >Would it be possible to build a significantly thick spacer to use FWD
> >wheels on a
> >Spridget or other LBC? It would seem to me that the proliferation of
>"compact
> >sports" as defined by carlisle productions, there have to be a lot of wheels
> >turning up in the used market.
> >
> >Has anyone tried it?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|