Do you have the same sender as before - is it just the tank that was
changed?
|-----Original Message-----
|From: Dave Hiley [mailto:dhiley@cadvision.com]
|Sent: Friday, June 14, 2002 1:18 PM
|To: spridgets@autox.team.net
|Subject: Fuel Gauge Problems Persist
|
|
|Greetings
|A month or so ago I sought the list's advice on for a fuel
|gauge reading
|problem. Unfortunately many of the replies I received are on
|a computer
|that is no longer living. Here is a brief recap of the
|problem and what I
|have done to try to resolve it.
|
|The gauge worked before I installed a new fuel tank.
|Now it reads full even when the tank is nearly empty.
|The tank is properly grounded.
|The sender unit cycles normally and smoothly when out of the tank and
|reads 15 ohms in the full position and approx. 250 ohms in the
|empty position.
|If I disconnect the power lead at the bullet connector near
|the front of
|the tank the gauge drops to empty.
|
|Is it possible that the gauge is the problem?
|Thanks
|Dave
|
|'72 Midget
|
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|