Advice needed again!
I took off the exhaust manifold tonight to fix a leak at the down pipe and
put on a new exhaust system. As I suspected the manifold to down pipe studs
are long gone and in their place were a few bolts and nuts of various sizes
left by one of the many previous owners. I cut the bolts off to separate
the exhaust pipe and what was left were large crudely cut oblong holes in
the flange. Can a machine shop weld up these holes and tap new threads for
suds in them or is there a better way to fix it? Help appreciated.
Mark
BN1 Nashville
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|