Typically there is a rather substantial bracket at the front left hand
corner of the gas tank with the rod attached to the right rear axle bracket
below the rear spring mounting point. Photos of a couple other designs are
also in Daniel's book.
The most important thing is that the bar be dead horizontal with the car on
a level surface and weighted as it will normally be driven (i.e. with the
driver installed..'-)
Gerard
At 11:30 AM -0600 6/3/02, ALEX VOLK wrote:
>Hello all,
>I was wondering if anyone out there had any information on a panhard rod for
>an early midget with 1/4 eliptic springs.
>I would like to fabricate (or buy) one but I need to know where & how they fit
>on. I know some chevys have them & they bolt to the diff cover.
>Any help will be MORE than appreciated
>Alex
>'61 midget
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|