Given that the loading on the dowels is in shear I would have though they
were extremely important, more so than the bolts although the bolts are
important too.
RS
In a message dated 22/05/02 09:58:51 Greenwich Standard Time,
DLancer7676@cs.com writes:
> I wouldn't think the locating pins would have to be hardened since they only
>
> locate the flywheel onto the crank and take little or no pressure. The
> hardened flywheel bolts, tightened to proper torque take the pressure.
>
> --David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|