Its been a heck of a long time since I had the double hub bearing setup
installed from the Winner's Circle and for the first time I am getting ready
to pull them. The question that I have for the list is what parts should I
have on hand to make sure that replacement goes smoothly? I can't remember
exactly what seals or stuff were required or how hard they were to fit (I'm
sure that I blocked all this out ~10 years ago), any tips?
There is nothing wrong with the setup, bearings are still good and the car
sees relatively little use, particularly in the last 4 years. The sole
reason that I am pulling the hubs is to fit a set of 8" Wolseley 1500 rear
brakes to get my parking brake back and improve the balance with the MGB
front brake setup installed on the front.
Jackson Zimmermann
jzimmerm@albemarle.org
'64 A-H Sprite (1275, 5-speed, and more...)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|