Hello Mike,
Monday, April 15, 2002, 12:56:11 PM, you wrote:
mmc> Bev,
mmc> Pull the hazard unit switch out, and clean all the contacts with a wire
brush or Dremel.
Some of the contacts are a pin that is very hard to reach. Take a
number 2 pencil and break off the eraser so you have about 4 inches of
pencil attached to the eraser. Check the eraser in a drill and spin
the contacts clean. Worked like a champ for me.
--
Best regards,
Bill mailto:w.gilroy@verizon.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|