yes you can
just remember a couple of things
You'll need more electrolyte, in a pool I'd use 50 - 80 pounds of soda ash
you'll need a LARGE anode or several anodes strategically placed
you'll either need a larger power supply or it will take a pretty long time
Also the solution gets pretty disgusting, so cleaning the pool would be a MAJOR
PAIN
However I have every intention of cleaning the frame for my MGA using a wood
frame, poly sheet and my welder as a power supply
"Mueller, Robert CDR" <RMueller@grumobile.uscg.mil> on 03/21/2002 09:31:30 AM
To: Tommy Samuels/MARKIVAUTO/US@MARKIVAUTO, spridgets@autox.team.net,
mgs@autox.team.net
cc:
Subject: RE: Electrolitic rust removal
If we use a swimming pool, can we dip an entire Spridget body?
-----Original Message-----
From Tommy_Samuels at markivauto.com [mailto:Tommy_Samuels@markivauto.com]
Sent: Thursday, March 21, 2002 6:09 AM
To: spridgets@autox.team.net; mgs@autox.team.net
Subject: Electrolitic rust removal
I set up my electrolitic rust removal system in the garage night before
last.
This set up ROCKS!!!!!
I did the prototype in a 5 gallon bucket and used a 6 amp battery charger
for the first test a dropped in a horribly rusted coil spring.
I connected the leads, turned on the power and 2 hours later washed all the
rust
off under warm water.
Tommy
61 MGA
67 Sprite
69 Sprite - parting out for $$ to restore my MGA
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|