Re: 1275 master cylinder

Michael O'Higgins wrote:
> 
>  can I use my original 7/8" bore slave cyl. With a 3" 1275 pushrod 

7/8 bore slave will work just fine. The 1275 pushrod should be 2 11/16" with a
stock clutch and flywheel.
You can make a pushrod out of a 3/8 bolt, a torch, big hammer, and a drill. Make
it a little long, grind it down as required. 
Never use too long of a pushrod, you will overthrow the clutch.
(or over disengage or over smash, something like that)
-- 

Frank Clarici
Toms River, NJ
A few Sprites
http://www.exit109.com/~spritenut