spridgets
[Top] [All Lists]

Re: Midget Rocker Panel Replacement

To: mts3@ra.msstate.edu, spridgets@autox.team.net
Subject: Re: Midget Rocker Panel Replacement
Date: Sun, 17 Feb 2002 20:32:34 EST
In a message dated 2/17/02 7:52:22 PM Eastern Standard Time, 
mts3@ra.msstate.edu writes:


> Is it possible to remove that part of the rocker panel without cutting
> the fender?
> 
> 

Tyson:

Yes it is possible. Drill out the bottom and rear spot welds first, and all 
others that you can see, then bend up the rocker panel.  You should be able 
to access the spot welds inside that hold the rocker panel to the rear fender.

--David C.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>