It will fit if you get a helper on the other side of the bug and
by severely stretching/elongating the rubber it will thin out as
you lay it inside the channel. Dry run first, then if you want
with contact cement.
Mike L
60A,67E,59Bug
----- Original Message -----
From Frank Clarici <spritenut at Exit109.com>
To: Dave <lbc@littlebitcountry.com>
Cc: Spridgets <spridgets@autox.team.net>
Sent: January 6, 2002 6:39 PM
Subject: Re: Bonnet Gasket
> Dave wrote:
> >
> > Does anyone have any idea on how to get the Bonnet gasket (the
one above the
> > firewall) to seat correctly?
>
> Don't buy it from mo$$ or VB!
> The correct one fits fine, I believe it is available from AH
Spares.
> You can either cut the one sold on this side of the pond or do
without it. I gave
> up and just do without.
>
> --
>
> Frank Clarici
> Toms River, NJ
> A few Sprites
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|