Sheldon-
Believe "Cannon" quality product from what I recall when running 45DCOE
"tuned" Vizard 1275+ application, years
ago. I had 6" variety (no "comments", please; I know what you're
thinking,
don't even bother to deny it, 'cause no
one's gonna believe you anyway!)
Longer 5 and 6 inch better for low and mid-range rpms; shorter better
for top end. 4" on shorter side but will fit with
"deep" (again, no comments guys!!)
3" K&N filter. Use fully rounded short
stacks within filter case, even if you have
to cut and reweld the 2&1/2" normally
available ones to do this. TWM (or whatever) has the fully rounded bells
available, maybe shorter than prev.
mentioned.
Min. space bwtn. end of stack and filter
case = inner diameter of bell at it's widest
point, as I recall.
Cap'n. Bob
'61 :{)
|