Bigger hammer, and give it a good ol' whack! Just put an old nut on the stud
first so you don't mash the threads.
Doug Ingram
----- Original Message -----
From Jeffrey H. Boatright <jboatri at emory.edu>
To: <spridgets@autox.team.net>
Sent: Tuesday, August 28, 2001 6:58 PM
Subject: studs
> I'm finally switching from wire to steel wheels. I need to use one of
> the hubs from the current set up for the steel wheel axle. The studs
> are too short from the wire wheel hubs for use with the steel wheels.
> So, I need to extract the studs from one set of hubs and put new,
> longer ones in (the old long ones are a little bent).
>
> So, how does one extract studs and insert new ones? I've banged on
> them a little with a hammer, but this doesn't seem to making an
> impression (pun intended).
>
> Thanks,
>
> Jeff
> --
|