How far are you unscrewing them?
You don't need to unscrew them more than half to 3/4 turn to do the job.
Gerard
>>if I unscrewed the valves to the recommended amount of turn.<<
At 9:38 AM -0700 8/22/01, ET Piano wrote:
> After overhauling the brakes in my 1979 Midget I ran into a problem when
>bleeding the system. The screw threads of the bleeding valves leaked a lot
>of fluid
if I unscrewed the valves to the recommended amount of turn. I
>don't remember this happening before. This even happened with two new drum
>brake slave cylinders. It was worst from one of my calipers that I
>overhauled, including removing and cleaning the bleed screw and aperature.
>
> The least amount of trouble was from the caliper that I overhauled without
>removing the bleed screw. (I forgot.) I infer that the accumulated crud
>around the screw threads of this bleed screw prevented brake fluid leaks.
>
>So, is there some goo that is safe to spread on brake bleed screws that acts
>like road gunk?
>
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|