Rick,
No welding required (unless somebody made some bad repair).From inside the
car, 4 bolts behind the kick panel, 3 vertically near the door and 1 near
the front lower footwell. Exterior: 1 bolt at the firewall, where the
bonnet and fender meet, 2 more above the grille, and 3 below the grille at
the valance. You may need to loosen or remove bolts from the front grille
surround/valance to get the fenders off though. there are also some bumper
support brackets that will need to be removed to allow the fender to come
off.
Gerard
At 8:46 AM -0700 8/10/01, ET Piano wrote:
>How are the fenders of a 1979 Midget attached? It looks like they are just
>bolted on, with some sort of tang holding the bottom. Is there any welding
>involved in removing the fenders?
>
>Thanks,
>Rick
>Lutherville, MD
>
>
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|